Contour™ 1-step Premium Body Filler actually inhibits rust and self-etches…kit also includes 5 spreaders and 100 mixing board sheets! Save time in your shop with our “all-in-1-step” custom-blended premium body filler. It contains rust inhibitors to prevent corrosion long after painting, and its unique self-etching properties bite into the surface for maximum adhesion.
Rust inhibitors prevent corrosion
Self-etching properties create excellent adhesion
1-step process; no glazing putty required
Includes 5 spreaders of different shapes
Plus mixing board with 100 tear-off sheets
Eastwood’s custom blended Premium Body Filler contains Rust Inhibitors to prevent corrosion long after paint has been applied. Its unique Self-Etching properties bite into the surface for excellent adhesion. This unique formula spreads and sand beautifully thus eliminating pinholes. Furthermore, its excellent feather-edging properties won’t clog up sandpaper. This premium Body Filler is a true one-step application as no glazing putties are required. Includes hardener, 5 pack of spreaders and Quick Mix Board with 100 sheets
13520zp Contour Premium Filler 102.4 oz /08 US gallon/ 3 liters Hardner: 2.75 oz/.78g 13919 5 pack of spreaders 31273 Quick Mix Board & Sheets
13521 ZP EW Contour Glazing Putty 10041Z PRE Painting Prep43120 43120 Eastwood Work-Fender Stand 43579 DA Orbiting Sander 31160 Dura Block Sanding Boards 21538 Larry Lyles Body Work DVD 12416z Guide Coat Aerosol
Thoroughly mix desired amount of material with cream hardener. Using a clean spreader, fill to desired level. Do not exceed 1/4″ depth. Allow to cure for at least 15 minutes before sanding. Abrade with 80-grit and follow up with 120-grit to achieve desired contour. Final finish with finer abrasives. If necessary, apply Eastwood’s 13521ZP Contour™ Glazing Putty for final finishing. Topcoat with quality primer, such as Eastwood’s Epoxy or Urethane Primers.
CAUTION: Do NOT return catalyzed material back into can. To avoid contamination, seal lid tightly after each use. Store in a cool dry place.
Always wear eye, skin and res[oratory protection when using this product. Always apply in a well ventilated area. Consult MSDS and product label for specific safety warnings.
Surface must be clean and free of wax, grease and debris. Abrade surface using 36 grit, or finer. Thoroughly mix desired amount of material with 2% liquid hardener. Do not exceed 1/4″ depth. Allow to cure 15 min before sanding. Abrade with 40-80 grit and follow up with 120 grit to desired contour 5. If necessary, apply Eastwood’s Polyester Glazing Putty (13521zp) for final finishing. Topcoat with quality primer such as Eastwood’s Epoxy or Urethane Primers. Do NOT return catalyzed material back into can.
Instructions and MSDS